Your client connection

Speed test

Run a browser-based speed test to check your connection to this .

Run speed test

Name
Network name
Hardware address
Product model


Ethernet	This is directly connected to a local network. Primary IP address: Primary IP address: This is acting as a repeater and has not detected a uplink connection on an Ethernet port. This is trying to join a network or find a working Ethernet connection. Primary IP address: This has detected an IP conflict on its uplink connection with another machine.
Internet	This is connected to the Internet. This is not connected to the Internet. This does not have a working DNS server.
	This is not connected to the . Make sure you can send outgoing traffic to UDP port 7351 through your firewall. Make sure you can send outgoing traffic to TCP port 7734 through your firewall. This is successfully connected to the .
Firmware

Status
IP
Type
Provider
Model
Access Point Name (APN)
Signal strength
Reference Signal Received Power (RSRP)
Reference Signal Received Quality (RSRQ)
Band

Hardware Addresss	Product Model	Current

SSID	BSSID	Channel	Signal (dB)	Mode	Encryption

Uplink configuration

Configure the uplink Internet connection on this .
Internet 1
- VLAN tagging
- VLAN ID
- Connection type
- IP assignment
- Address
- Netmask
- Gateway
- DNS server 1
- DNS server 2
- Authentication
- Username
- Password
- IP assignment
- Address
Internet 2
- Role
- VLAN tagging
- VLAN ID
- Connection Type
- IP assignment
- Address
- Netmask
- Gateway
- DNS server 1
- DNS server 2
- Authentication
- Username
- Password
- IP assignment
- Address
Uplink configuration

Configure the uplink Internet connection on this .
IP configuration
- IP assignment
- VLAN
- Address
- Netmask
- Gateway
- DNS server 1
- DNS server 2
Site survey

In site survey mode, the AP will always broadcast the open SSID site_survey-<MAC address> and will not check for connectivity with the . This mode should only be used to perform a site survey, not for serving wireless clients.
- Survey mode?
Web proxy

HTTP will be used for the device to communicate with the if UDP communication is blocked
- Use a proxy?
- Hostname or IP
- Port
- Authentication
- Username
- Password
Save
Download support data

Download diagnostic information about this device for Support to examine. This can take several minutes.

Do this only if requested by Cisco Meraki Support.
Ethernet configuration

Use this page to configure physical link settings on the Ethernet ports.

Save

Incorrect password

You've entered incorrect login credentials. The default login is the serial number (e.g. Qxxx-xxxx-xxxx), with no password. The serial number is on the bottom or back of the device.

Try again